I have just discovered a considerable amount of play in the rear wheel of my C1 Exec (30k miles).
I presume this is the rear wheel bearings, which I believe are different from the Front Bearings.
Has anyone published a guide to replacing the rear bearings, and where they can be sourced, any other parts/kit required?
Thanks in anticipation of your help
You sure it isn't just a loose nut? It's unusual for these bearings to go and replacement isn't as straightforward as front ones. The bearing itself is a 6205 2RS C3 (two rubber seals and a larger than standard radial clearance) available from any bearing stockist/motor factor/ebay!
I will dismantle today to check it over
Thanks for your input
Found the problem thanks.
The central wheel nut was not tight as you predicted, pulling it up to the correct torque removed the problem.
While I was in there I replaced the rear disk and pads (all EBC parts) and made sure that everything else was tight and orientation of spacer was correct.
Thanks for your help
Glad it was so simple :-)
needs to be torqued to 130nm,s
Powered by mwForum 2.29.3 © 1999-2013 Markus Wichitill